Design of grounding system of propulsion coils for low-vacuum tube maglev train
-
摘要: 为研究超高速低真空管道磁悬浮列车推进线圈接地系统及过电压分布特性,建立了包含地面推进线圈、金属低真空管道及分布式接地装置的双端口等值电路模型,结合已发表文献的数据对等值电路模型进行准确性验证,基于该模型分析雷电过电压下推进线圈的电压响应分布特性,从推进线圈接地点数量和纵向接地线与金属低真空管道间绝缘电阻2个维度优化了接地系统设计。分析结果表明:雷击位于推进线圈上时,会引起局部过电压的产生,但是其他位置线圈的过电压会通过接地得到抑制;在2个接地点之间,因与接地点距离变化引起的电压呈现先上升再下降的趋势;金属低真空管道起到避雷带的作用,保证雷击不会直接作用到推进线圈上,同时与推进线圈连接地的纵向接地线和金属低真空管道之间存在绝缘电阻,可以有效保证过电压被抑制到小于1.0;纵向接地线和金属低真空管道间绝缘电阻的阻值显著影响推进线圈的过电压程度,当阻值大于10 kΩ时,可以保证沿线所有的推进线圈过电压小于1.0。因此,可通过对接地点数量以及纵向接地线与金属低真空管道间电阻双参数进行优化配置,实现在保证系统安全性的前提下,降低工程实施成本,为超高速低真空管道磁浮列车的工程化应用提供了理论依据与技术支撑。Abstract: To study the grounding system of propulsion coils and the distribution of overvoltage characteristics for low-vacuum tube maglev train, a dual-port equivalent circuit model including ground propulsion coils, a metal low-vacuum tube, and distributed grounded devices was established. The accuracy of the equivalent circuit model was verified with data from published literature. Based on this model, the voltage response distribution characteristics of propulsion coils under lightning overvoltage were analyzed. The grounding system design was optimized from two dimensions: the number of ground points of propulsion coils as well as the insulation resistance between longitudinal grounded lines and the metal low-vacuum tube. Analysis results show that when lightning strikes the propulsion coils, local overvoltage is induced, but the overvoltage of other propulsion coils is suppressed by grounding. Between two ground points, the voltage changes with the distance from the ground points. The voltage shows a trend of first rising and then falling. The metal low-vacuum tube acts as a lightning protection strip to ensure that lightning cannot strike the propulsion coils directly. Meanwhile, insulation resistance exists between the longitudinal grounded lines (connected to the propulsion coils) and the metal low-vacuum tube, which effectively ensures that the overvoltage is suppressed to less than 1.0. The insulation resistance value between longitudinal grounded lines and the metal low-vacuum tube significantly affects the overvoltage level in propulsion coils. When the resistance value is greater than 10 kΩ, the overvoltage of all propulsion coils along the line can be guaranteed to be less than 1.0. Therefore, the configuration can be optimized with two parameters, namely, the number of ground points and the resistance between longitudinal grounded lines and the metal low-vacuum tube. Thus, the engineering implementation cost can be reduced while ensuring system safety. A theoretical basis and technical support is provided for the engineering application of ultra-high-speed low-vacuum tube maglev trains.
-
表 1 缩比推进线圈和雷电波形的电气参数
Table 1. Electrical parameters of the scaled propulsion coil and the lightning wave
参数 符号 数值 线圈电感/mH Lc 0.67 分布电容/pF Cc 215 冲击电阻/Ω Rc 50 对地电容/ pF Cg 50 雷电波形/μs Tf/Tt 0.4/50 雷电幅值/V Vm 50 -
[1] PIERREJEAN L, RAMETTI S, HODDER A, et al. A review of modeling, design and performance assessment of linear electromagnetic motors for high-speed transportation systems[J]. IEEE Transactions on Transportation Electrification, 2025, 11(1): 2146-2159. doi: 10.1109/TTE.2024.3416870 [2] 邓自刚, 刘宗鑫, 李海涛, 等. 磁悬浮列车发展现状与展望[J]. 西南交通大学学报, 2022, 57(3): 455-474, 530.DENG Zi-gang, LIU Zong-xin, LI Hai-tao, et al. Development status and prospect of maglev train[J]. Journal of Southwest Jiaotong University, 2022, 57(3): 455-474, 530. [3] SHI Y, MA W H, LI M, et al. Research on dynamics of a new high speed maglev vehicle[J]. Vehicle System Dynamics, 2022, 60(3): 721-742. doi: 10.1080/00423114.2020.1838568 [4] 熊嘉阳, 沈志云, 池茂儒, 等. 高速磁悬浮列车技术综述[J]. 交通运输工程学报, 2025, 25(2): 1-23. doi: 10.19818/j.cnki.1671-1637.2025.02.001XIONG Jia-yang, SHEN Zhi-yun, CHI Mao-ru, et al. Review on high-speed maglev train technology[J]. Journal of Traffic and Transportation Engineering, 2025, 25(2): 1-23. doi: 10.19818/j.cnki.1671-1637.2025.02.001 [5] 马文忠, 李耀华. 新型绕组电缆及其接地系统的研究[J]. 电线电缆, 2004, 47(3): 32-33, 35.MA Wen-zhong, LI Yao-hua. Study on the new winding cable and its grounding system[J]. Wire & Cable, 2004, 47(3): 32-33, 35. [6] 邓江明, 陈特放, 彭奇彪. 中低速磁浮列车车体接地回流特性研究[J]. 机车电传动, 2017, 5: 88-92.DENG Jiang-ming, CHEN Te-fang, PENG Qi-biao. Study of grounding current characteristics of power supply main loop in the medium-low speed maglev system[J]. Electric Drive for Locomotives, 2017, 5: 88-92. [7] 宋丽伟, 李林, 邓江明. 磁浮列车牵引系统电磁干扰分析研究[J]. 电气传动自动化, 2019, 41(6): 9-12.SONG Li-wei, LI Lin, DENG Jiang-ming. Analysis and research on electromagnetic interference of maglev train traction system[J]. Electrical Drive Automation, 2019, 41(6): 9-12. [8] 苏鹏程. 客运专线电气化铁道的综合接地技术[C]//电气化铁道. 中国电气化铁路两万公里学术会议论文集. 北京: 电气化铁道, 2005: 39-42.SU Peng-cheng. Integrated grounding technology for electrified passenger dedicated lines[C]//Electric Railway. Proceedings of the 20000 Miles Academic Conference on China's Electrified Raiway. Beijing: Electric Railway, 2005: 39-42. [9] 杨岗, 刘立峰, 余颜丽. 铁路综合接地和信号设备防雷系统工程设计指南[M]. 北京: 中国铁道出版社, 2009.YANG Gang, LIU Li-feng, YU Yan-li. Guidelines for the engineering design of lightning protection systems for integrated grounding and signaling equipment for railways[M]. Beijing: China Railway Press, 2009. [10] 李响. 运营动车组车轨回流耦合特性研究[D]. 成都: 西南交通大学, 2018.LI Xiang. Study on the coupling characteristics of high-speed EMU's car-rail reflux coupling system[D]. Chengdu: Southwest Jiaotong University, 2018. [11] 刘东来. 高速动车组接地技术研究[D]. 成都: 西南交通大学, 2013.LIU Dong-lai. Study on grounding technology of high-speed trains[D]. Chengdu: Southwest Jiaotong University, 2013. [12] 刁超健. 高速动车组保护接地性能分析及优化方法研究[D]. 成都: 西南交通大学, 2019.DIAO Chao-jian. Research on performance analysis and optimization method of protective grounding of high speed EMU[D]. Chengdu: Southwest Jiaotong University, 2019. [13] DENG Z G, SHI H F, CHEN Y H, et al. A cost-effective linear propulsion system featuring PMEDW for HTS maglev vehicle: Design, implementation, and dynamic test[J]. Measurement, 2025, 240: 115618. doi: 10.1016/j.measurement.2024.115618 [14] SHI H F, DENG Z G, KE Z H, et al. Linear permanent magnet electrodynamic suspension system: Dynamic characteristics, magnetic-mechanical coupling and filed test[J]. Measurement, 2024, 225: 113960. doi: 10.1016/j.measurement.2023.113960 [15] KIM S H, LEE J, KIM C S, et al. Drag force analysis of superconducting EDS type Hyperloop system according to changes in tube material properties[C]//IEEE. 2024 IEEE International Magnetic Conference. New York: IEEE, 2024: 1-2. [16] CHOI S Y, CHO M K, LIM J Y. Electromagnetic drag forces between HTS magnet and tube infrastructure for Hyperloop[J]. Scientific Reports, 2023, 13: 12626. doi: 10.1038/s41598-023-39916-7 [17] CHOI S Y, LEE C Y, LIM J Y. Analysis of guidance and levitation forces between HTS magnets and conductive tubes for Hyperloop[J]. AIP Advances, 2024, 14(3): 1-13. [18] CHOI S Y, LEE C Y, JO J M, et al. Sub-sonic linear synchronous motors using superconducting magnets for the Hyperloop[J]. Energies, 2019, 12(24): 1-18. [19] DONG F L, HUANG Z, QIU D R, et al. Design and analysis of a small-scale linear propulsion system for maglev applications (1)— the overall design process[J]. IEEE Transactions on Applied Superconductivity, 2019, 29(2): 1-5. [20] SADEGHI S, SAEEDIFARD M, BOBKO C. Dynamic modeling and simulation of propulsion and levitation systems for Hyperloop[C]//IEEE. 2021 13th International Symposium on Linear Drives for Industry Applications (LDIA). New York: IEEE, 2021: 1-5. [21] SADEGHI S, FENET F X, HASSANPOUR A, et al. An optimized electric propulsion system for Hyperloop applications[J]. IEEE Transactions on Transportation Electrification, 2023, 9(2): 2723-2733. doi: 10.1109/TTE.2022.3226399 [22] KUPTSOV V, FAJRI P, RASHEDUZZAMAN M, et al. Combined propulsion and levitation control for maglev/hyperloop systems utilizing asymmetric double-sided linear induction motors[J]. Machines, 2022, 10(131): 1-15. [23] JI W Y, JEONG G, PARK C B, et al. A study of non-symmetric double-sided linear induction motor for Hyperloop all-in-one system (propulsion, levitation and guidance)[J]. IEEE Transactions on Magnetics, 2018, 54(11): 1-4. [24] LIM J Y, LEE C Y, LEE J H, et al. Design model of null-flux coil electrodynamic suspension for the Hyperloop[J]. Energies, 2020, 13(19): 5075-1-21. [25] LIM J Y, LEE C Y, OH Y J, et al. Performance evaluation of superconducting electrodynamic suspension for Hyperloop using static experiments[J]. IEEE Transactions on Applied Superconductivity, 2024, 34(5): 1-6. [26] AMETANI A, NISHINAGA H, KATO R, et al. A study of transient induced voltages on a maglev train coil system[C]//IEEE. Proceedings of IEEE Vehicular Technology Conference, Stockholm. New York: IEEE, 1994: 1374-1378. [27] EMA S. Surge analysis of the MAGLEV coil for propulsion and guidance[J]. Electrical Engineering in Japan, 1997, 118(1): 71-82. doi: 10.1002/(SICI)1520-6416(19970115)118:1<71::AID-EEJ7>3.0.CO;2-K [28] LI Q J, HU D Y, CHENG L, et al. Stability study of epoxy resin in low-vacuum environment applied in ground coil module of high-speed flying train[C]//Springer. The Proceedings of the 18th Annual Conference of China Electrotechnical Society (ACCES 2023). Munich: Springer, 2023: 41-58. -
下载: