Measurement and performance analysis of switch signal for automotive electrical acceleration pedal
-
摘要: 设计了基于非接触式电子油门踏板角位移传感器的测试系统, 研究了踩踏速度与采样频率对怠速开关信号输出特性的影响。采用ADLink-PCI911DG数椐采集卡和PCI-DAQ虚拟仪器技术, 将油门踏板角位移传感器信号经A/D转换, 然后通过DAQ驱动程序, 结合LabVIEW软件开发平台, 编写了测试程序, 实现了全自动数据采样。同时进行了油门踏板的快踩快放、慢踩慢放、快踩慢放和慢踩快放等工况试验, 分析了影响电子油门踏板开关信号的关键因素。分析结果表明: 踩踏速度和采样频率是影响信号测量精度的主要因素, 为了保证测量精度, 系统的采样频率应不小于1 000 Hz; 快踩快放时怠速开关信号的误差值最大, 慢踩慢放的误差最小, 由此提出了误差产生原因及解决措施。Abstract: A test system of automotive electrical acceleration pedal was designed based on non-contact angle replacement sensor and the output characteristics of idle switch due to stampeding speeds and sampling frequencies. With ADLink-PCI911DG acquisition card, PCI-DAQ virtual instrument technology and LabVIEW software, the angle sensor signal was transferred by A/D, was driven by DAQ, and the data acquisition was realized automatically. The key factors that affected the switch signal of electrical acceleration pedal were analyzed under fast press and fast release, fast press and slow release, slow press and fast release, slow press and slow release.The result shows that the speeds and frequencies are main influence factors, and the sampling frequencies are not less than 1 000 Hz to ensure measuring precision. The measuring errors are minimal under slow press and slow release, and the errors are maximal under fast press and fast release. Based on the result, some error reasons and solving measures are proposed.
-
表 1 高频采样试验开关点电压
Table 1. Switch voltages in high sampling frequency experiment
mV 工况 采样频率/Hz 8 000 5 000 2 000 1 000 开关点1 开关点2 开关点1 开关点2 开关点1 开关点2 开关点1 开关点2 快踩快放 714.4 711.8 721.7 711.5 716.7 715.4 723.6 721.9 慢踩快放 718.3 716.4 717.6 715.5 717.6 716.9 715.6 714.3 快踩慢放 719.4 717.2 717.6 712.9 717.3 713.5 716.1 715.4 慢踩慢放 717.6 716.6 717.8 712.8 713.2 714.6 718.6 716.2 表 2 低频采样试验开关点电压
Table 2. Switch voltages in low sampling frequency experiment
mV 工况 采样频率/Hz 900 800 500 300 开关点1 开关点2 开关点1 开关点2 开关点1 开关点2 开关点1 开关点2 快踩快放 726.4 732.6 720.7 743.1 721.4 739.3 704.1 780.1 732.5 713.4 714.3 723.6 764.6 712.9 727.0 879.2 725.9 746.1 732.1 722.6 782.2 772.4 722.8 841.2 慢踩快放 717.2 743.1 746.2 722.3 710.5 793.6 711.5 831.6 720.6 750.3 726.1 732.8 753.1 723.4 716.3 767.4 715.9 726.6 732.6 754.3 743.2 783.5 718.3 839.3 快踩慢放 738.7 724.9 747.1 721.3 782.7 746.3 724.1 720.7 704.8 726.1 735.1 722.1 746.3 735.8 724.1 721.3 717.9 738.5 733.2 715.3 763.4 730.8 719.8 721.4 慢踩慢放 716.2 721.7 736.8 738.7 736.9 743.3 711.6 725.8 718.6 713.8 732.3 748.1 713.4 746.7 716.5 716.8 725.4 721.7 715.3 736.6 719.4 722.1 712.4 729.8 -
[1] 冯能莲, 董春波, 宾洋, 等. 电子节气门控制系统研究[J]. 汽车技术, 2004, 35 (1): 1-4. https://www.cnki.com.cn/Article/CJFDTOTAL-QCJS200903006.htmFENG Neng-lian, DONG Chun-bo, BIN Yang, et al. Study on electronic throttle control systems[J]. Automobile Technology, 2004, 35 (1): 1-4. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-QCJS200903006.htm [2] 李孟良, 苏茂辉, 秦孔建, 等. 实际行驶工况下柴油车发动机负荷分布及排放[J], 江苏大学学报: 自然科学版, 2007, 28 (3): 213-215.LI Meng-liang, SU Mao-hui, QIN Kong-jian, et al. Diesel engine load distribution and exhaust emissions under real-world driving condition[J]. Journal of Jiangsu University: Natural Science Edition, 2007, 28 (3): 213-215. (in Chinese) [3] 姚春德, 杨广峰, 倪培永, 等. 车用汽油机燃油空气加热器试验[J]. 中国公路学报, 2009, 22 (1): 116-119, 126. https://www.cnki.com.cn/Article/CJFDTOTAL-ZGGL200901021.htmYAO Chun-de, YANG Guang-feng, NI Pei-yong, et al. Tests of air heater heated by fuel for gasoline engine of vehicle[J]. China Journal of Highway and Transport, 2009, 22 (1): 116-119, 126. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-ZGGL200901021.htm [4] 罗开玉, 李伯全, 王小飞, 等. 基于虚拟仪器的机械转子轴心轨迹分析[J], 江苏大学学报: 自然科学版, 2008, 29 (6): 474-477.LUO Kai-yu, LI Bo-quan, WANG Xiao-fei, et al. Study on mechanical rotor axis locus based on virtual instrument[J]. Journal of Jiangsu University: Natural Science Edition, 2008, 29 (6): 474-477. (in Chinese) [5] 张宏群, 蔡国英. 基于虚拟仪器技术的信号测量分析仪的设计[J]. 计算机技术与发展, 2008, 18 (2): 244-246, 250. https://www.cnki.com.cn/Article/CJFDTOTAL-WJFZ200802070.htmZHANG Hong-qun, CAI Guo-ying. Design of signal measuring and analyzing based on virtual instrument technology[J]. Computer Technology and Development, 2008, 18 (2): 244-246, 250. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-WJFZ200802070.htm [6] 郑挺, 王勇. 虚拟仪器技术在自动测试系统中的应用[J]. 中国测试技术, 2006, 32 (1): 42-43. https://www.cnki.com.cn/Article/CJFDTOTAL-SYCS200601013.htmZHENG Ting, WANG Yong. Application of the virtual instrument technologyinthe automatic testing system[J]. China Measurement Technology, 2006, 32 (1): 42-43. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-SYCS200601013.htm [7] 张红光, 何洪, 刘兴华, 等. 车用大功率柴油机电控喷油系统的开发研究[J]. 中国公路学报, 2003, 16 (2): 103-107. https://www.cnki.com.cn/Article/CJFDTOTAL-ZGGL200302025.htmZHANG Hong-guang, HE Hong, LI U Xing-hua, et al. Study of development of the electronically controlled fuel injection system of heavy duty diesel engine for vehicle[J]. China Journal of Highway and Transport, 2003, 16 (2): 103-107. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-ZGGL200302025.htm [8] 哈里德, 李兵, 边耀璋. 小波分析在电控发动机故障诊断中的应用[J]. 长安大学学报: 自然科学版, 2007, 27 (3): 88-92. https://www.cnki.com.cn/Article/CJFDTOTAL-XAGL200703019.htmHALIDE, LI Bing, BI AN Yao-zhang. Wavelet analysis method for faults diagnosisin electronic controlled engine[J]. Journal of Chang an University: Natural Science Edition, 2007, 27 (3): 88-92. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-XAGL200703019.htm [9] 庞罕, 张为公, 王霞, 等. 基于虚拟试验场技术的越野车辆地形通过性评价系统[J]. 交通运输工程学报, 2009, 9 (2): 79-82. http://transport.chd.edu.cn/article/id/200902014PANG Han, ZHANG Wei-gong, WANG Xia, et al. Terrain trafficability esti mating system of off-road vehicle based on virtue proving ground technology[J]. Journal of Traffic and Transportation Engineering, 2009, 9 (2): 79-82. (in Chinese) http://transport.chd.edu.cn/article/id/200902014 [10] 张可鑫, 吴永红, 王利革, 等. 角位移传感器校准方法及不确定度分析[J]. 航空计测技术, 2004, 24 (5): 29-31. https://www.cnki.com.cn/Article/CJFDTOTAL-HKJC200405011.htmZHANG Ke-xin, WU Yong-hong, WANG Li-ge, et al. Calibration of angle displacement sensor and analysis of uncertainty[J]. Aviation Metrology and Measurement Technology, 2004, 24 (5): 29-31. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-HKJC200405011.htm -