Practical updating method of finite element model for long-span steel truss suspension bridge
-
摘要: 以沪蓉国道四渡河深切峡谷特大钢桁架悬索桥为工程背景, 综合考虑悬索桥结构非线性与重力刚度因素影响, 采用ANSYS的APDL语言编写桥梁模型修正优化程序, 实现了有限元分析和模型修正的同步计算。通过对比不同的优化算法、不同的目标函数与不同的约束条件对模型修正效果的影响程度, 并结合实测吊杆力数据和考虑伸缩缝刚度参数影响, 提出了一种全面反映悬索桥结构特性的桥梁有限元模型实用修正方法。采用频率残差目标函数, 将频率、振型参数与其他静力信息作为约束条件, 进行了模型零阶优化计算。计算结果表明: 修正后模型的结构静动力计算响应与实测响应之间的误差明显减小, 各测点静力变形误差小于8%, 振动频率误差小于5%, 并且有限元模型的参数变化合理, 保证了参数本身的物理意义, 从而利用修正方法获得了四渡河特大桥的基准有限元模型。Abstract: Based on the engineering background of the super long-span steel truss suspension bridge over Sidu River Deep-Cutting Gorge on Hu-Rong National Highway, the influences of suspension bridge structural nonlinear and gravity stiffness were comprehensively considered, an updating programme of bridge model was developed by using APDL of ANSYS, and the synchronous calculation on finite element analysis and model updating was realized.The influence degrees of different optimization algorithms, different objective functions and different constraint conditions on model updating effects were compared, the influences of measured suspender forces and expansion joint rigidity parameters were analyzed, and a practical updating method, which could fully reflect the structural properties of suspension bridge, was proposed.In the method, the frequency residual was taken as objective function, the frequency, modal parameters and other static information were taken as constraint conditions, and the zero order optimization was carried out.Calculation result shows that the deviations between the computed and measured responses of structural static and dynamic forces for the updating model decrease significantly, the static deformation errors are controlled within 8%, the frequency errors are controlled within 5%, the parameter variations of the model are reasonable, the physical meanings of the parameters are ensured, so the benchmark finite element model of super large bridge over Sidu River is obtained and feasible.
-
图 6 上游吊杆实测频率和索力
Figure 6. Measured frequencies and cable forces of upstream suspenders
图 7 配对后一阶侧弯、扭转与竖弯振型对比
Figure 7. Comparison of first lateral bending, torsional and vertical bending vibration modes after paired
图 9 采用不同计算方法的频率误差与修正参数变化率对比
Figure 9. Comparison of frequency errors and change rates ofcorrect parameters with different computation methods
图 11 采用不同目标函数的频率误差与修正参数变化率对比
Figure 11. Comparison of frequency errors and change rates of correct parameters with different objective functions
图 12 优化迭代过程中参数的变化
Figure 12. Variations of parameters in optimization and iteration process
图 13 优化振型和测试振型的比较
Figure 13. Comparison of optimization vibration modes and test vibration modes
表 3 有限元模型参数修正前后的比较
Table 3. Comparison of finite element model parameters before and after updating
下载: 导出CSV
-
[1] 刘健新, 李加武. 中国西部地区桥梁风工程研究[J]. 建筑科学与工程学报, 2005, 22 (4): 32-39. doi: 10.3321/j.issn:1673-2049.2005.04.007LI UJian-xin, LI Jia-wu. Study of wind project of bridge inwestern area of China[J]. Journal of Architecture and Civil Engineering, 2005, 22 (4): 32-39. (in Chinese) doi: 10.3321/j.issn:1673-2049.2005.04.007 [2] 李兆霞, 李爱群, 陈鸿天, 等. 大跨桥梁结构以健康监测和状态评估为目标的有限元模拟[J]. 东南大学学报: 自然科学版, 2003, 33 (5): 562-572. doi: 10.3321/j.issn:1001-0505.2003.05.007LI Zhao-xia, LI Ai-qun, CHEN Hong-tian, et al. Finite element modeling for health monitoring and condition assessment of long-span bridges[J]. Journal of Southeast University: Natural Science Edition, 2003, 33 (5): 562-572. (in Chinese) doi: 10.3321/j.issn:1001-0505.2003.05.007 [3] 宗周红, 夏樟华. 联合模态柔度和静力位移的桥梁有限元模型修正方法[J]. 中国公路学报, 2008, 21 (6): 43-49. doi: 10.3321/j.issn:1001-7372.2008.06.008ZONG Zhou-hong, XIA Zhang-hua. Finite element model updating method of bridge combined modal flexibility and static displacement[J]. China Journal of Highway and Transport, 2008, 21 (6): 43-49. (in Chinese) doi: 10.3321/j.issn:1001-7372.2008.06.008 [4] 任伟新, 陈华斌. 基于响应面的桥梁有限元模型修正[J]. 土木工程学报, 2008, 41 (12): 73-78. doi: 10.3321/j.issn:1000-131X.2008.12.012REN Wei-xin, CHEN Hua-bin. Response-surface based onfinite element model updating of bridge structures[J]. ChinaCivil Engineering Journal, 2008, 41 (12): 73-78. (in Chinese) doi: 10.3321/j.issn:1000-131X.2008.12.012 [5] JAISHI B, REN Wei-xin. Structural finite element model updating using ambient vibration test results[J]. Journal of Structural Engineering, 2005, 131 (4): 617-628. doi: 10.1061/(ASCE)0733-9445(2005)131:4(617) [6] ESTES A C, ASCE M, FRANGOPOL D M, et al. Updating bridge reliability based on bridge management systems visualin spection results[J]. Journal of Bridge Engineering, 2003, 8 (6): 374-382. doi: 10.1061/(ASCE)1084-0702(2003)8:6(374) [7] BROWNJOHNJ M W, MOYO P, DMENZETTER P, et al. Assessment of highway bridge upgrading by dynamic testing and finite-element model updating[J]. Journal of Bridge Engineering, 2003, 8 (3): 162-172. doi: 10.1061/(ASCE)1084-0702(2003)8:3(162) [8] BROWNJOHNJ M W, XI A Pin-qi. Dynamic assessment ofcurved cable-stayed bridge by model updating[J]. Journal of Structural Engineering, 2000, 126 (2): 252-260. doi: 10.1061/(ASCE)0733-9445(2000)126:2(252) [9] ZHANG Q W, CHANG T Y P, CHANG C C. Finite-elementmodel updating for the Kap Shui Mun Cable-Stayed Bridge[J]. Journal of Bridge Engineering, 2001, 6 (4): 285-293. [10] 姚昌荣, 李亚东. 基于静动力测试数据的斜拉桥模型修正[J]. 铁道学报, 2008, 30 (3): 65-70. https://www.cnki.com.cn/Article/CJFDTOTAL-TDXB200803014.htmYAO Chang-rong, LI Ya-dong. Updating of cable-stayed bridges model based on static and dynamictest data[J]. Journal of the China Railway Society, 2008, 30 (3): 65-70. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-TDXB200803014.htm [11] 郭彤, 李爱群, 费庆国, 等. 零阶与一阶优化算法在悬索桥模型修正中的应用对比分析[J]. 振动与冲击, 2007, 26 (4): 35-38, 68, 167-168. https://www.cnki.com.cn/Article/CJFDTOTAL-ZDCJ200704008.htmGUO Tong, LI Ai-qun, FEI Qing-guo, et al. Application comparison between zero-order and first-order optimization methods in model updating of suspension bridges[J]. Journal of Vibration and Shock, 2007, 26 (4): 35-38, 68, 167-168. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-ZDCJ200704008.htm [12] 李枝军, 李爱群, 韩晓林. 润扬大桥悬索桥动力特性分析与实测变异性研究[J]. 土木工程学报, 2010, 43 (4): 92-98. https://www.cnki.com.cn/Article/CJFDTOTAL-TMGC201004017.htmLI Zhi-jun, LI Ai-qun, HAN Xiao-lin. Dynamic analysis and experimental study of variations of the dynamic parameters of the Runyang Suspension Bridge[J]. China Civil Engineering Journal, 2010, 43 (4): 92-98. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-TMGC201004017.htm [13] 李永庆. 基于静动力有限元模型修正的梁格法车桥耦合振动程序开发及试验验证[D]. 西安: 长安大学, 2010.LI Yong-qing. Programdevelopment and experi mental validation of vehicle-bridge coupling vibration with grillage method based on static and dynamic finite element model updating[D]. Xian: Changan University, 2010. (in Chinese) -
点击查看大图
计量
- 文章访问数: 594
- HTML全文浏览量: 83
- PDF下载量: 385
- 被引次数: 0
