Failure mode analysis of hinged voided slab with gate-type steel rebars at bottom of junction surface
-
摘要: 以在空心板与铰缝构造结合面底部布设门式钢筋的深铰缝构造为研究对象, 参照2007年交通运输部颁布的装配式空心板桥标准图, 设计了一跨8 m足尺模型, 通过试验和非线性有限元法分析了车辆荷载作用下铰接空心板破坏类型、破坏位置与开裂荷载等破坏模式。分析结果表明: 试验验证了铰接空心板非线性有限元模型能较好地模拟铰接空心板在车辆荷载作用下的受力性能; 在空心板与铰缝结合面的三个方向的黏结滑移关系中, 应以竖向相对滑移量作为结合面黏结破坏失效的指标; 在车辆荷载作用下, 空心板与铰缝结合面是最薄弱的受力部位, 当荷载达到69 kN(0.99倍车辆荷载)时, 空心板与铰缝结合面底部开裂, 但当荷载达到85 kN(1.21倍车辆荷载)时, 空心板跨中截面底部才出现横向裂缝; 与在结合面底部不设门式钢筋的空心板相比, 在结合面底部设置门式钢筋后虽不能明显提高铰缝构造的开裂荷载, 但可以将铰缝通缝荷载从140 kN(2.00倍车辆荷载)提高至199 kN(2.84倍车辆荷载), 且不出现贯通的纵桥向裂缝。Abstract: Focused on the full-depth hinged joint with gate-type steel rebars at the bottom of junction surface between voided slab and hinged joint, a full-scale model with one span of 8 m according to the standard drawings of hinged voided slab bridge issued by Ministry of Transportation in 2007 was designed. With experiment and nonlinear finite element method, the failure modes of hinged voided slab under vehicle load were studied, including failure type, failure position and cracking load. Analysis result indicates that the nonlinear finite element model can properly simulate the mechanical properties of hinged voided slab under vehicle load by comparing with experimental result. The vertical relative slip is regarded as the index of cohesion failure of junction surface in three directions of bonding-slip relationship. Under vehicle load, the weakest position is the junction surface between voided slab and hinged joint. The surface starts to crack when the load reaches 69 kN(0.99 times of vehicle load), but the crack appears at the middle of voided slab when the load reaches 85 kN(1.21 times of vehicle load). Compared with the experiment on hinged voided slab with full-depth joint without gate-type steel rebars, when the gate-type steel rebars are laid at the bottom of junction surface, the cracking load increases unobvious, but the load that through cracks appear along the intersection between slab and hinged joint increases from 140 kN(2.00 times of vehicle load)to 199 kN(2.84 times of vehicle load), and through crack along longitudinal direction can be prevented.
-
图 16 图 16结合面黏结滑移曲线
Figure 16. Bonding-slipping curves of junction surface
表 1 混凝土本构关系参数
Table 1. Constitutive relation parameters of concretes
表 2 ηi-j计算结果
Table 2. Computation result ofηi-j
% 表 3 铰缝构造破坏模式
Table 3. Failure modes of hinged joint
表 4 空心板破坏模式
Table 4. Failure mode of voided slab
-
[1] 王渠, 吴庆雄, 陈宝春. 装配式空心板桥铰缝破坏模式试验研究[J]. 工程力学, 2014, 31(增): 115-120. https://www.cnki.com.cn/Article/CJFDTOTAL-GCLX2014S1022.htmWANG Qu, WU Qing-xiong, CHEN Bao-chun. Test study on the failure mode of hinged joint in assembly voided slab bridge[J]. Engineering Mechanics, 2014, 31(S): 115-120. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-GCLX2014S1022.htm [2] 陈悦驰, 吴庆雄, 陈宝春. 装配式空心板桥铰缝破坏模式有限元分析[J]. 工程力学, 2014, 31(增): 51-58. https://www.cnki.com.cn/Article/CJFDTOTAL-GCLX2014S1012.htmCHEN Yue-chi, WU Qing-xiong, CHEN Bao-chun. Failure mode of hinged joint in assembly voided slab bridge by finite element analysis[J]. Engineering Mechanics, 2014, 31(S): 51-58. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-GCLX2014S1012.htm [3] HANNA K E, MORCOUS G, TADROS M K. Transverse post-tensioning design and detailing of precast prestressed concrete adjacent-box-girder bridges[J]. PCI Journal, 2009, 54(4): 160-174. https://trid.trb.org/view/904072 [4] HUCKELBRIDGE A A, EL-ESNAWI H, MOSES F. Shear key performance in multibeam box girder bridges[J]. Journal of Performance of Constructed Facilities, 1995, 9(4): 271-285. doi: 10.1061/(ASCE)0887-3828(1995)9:4(271) [5] EL-REMAILY A, TADROS M K, YAMANE T, et al. Transverse design of adjacent precast prestressed concrete box girder bridge[J]. PCI Journal, 1996, 41(4): 96-113. doi: 10.15554/pcij.07011996.96.113 [6] HANNA K E. Behavior of adjacent precast prestressed concrete box girder bridges[D]. Lincoln: University of Nebraska, 2008. [7] ANNAMALAI G, BROWN R C. Shear strength of post-tensioned grouted keyed connections[J]. PCI Journal, 1990, 35(3): 64-73. doi: 10.15554/pcij.05011990.64.73 [8] MILLER R A, HLAVACS G M, LONG T, et al. Full-scale testing of shear keys for adjacent box girder bridges[J]. PCI Journal, 1999, 44(6): 80-90. doi: 10.15554/pcij.11011999.80.90 [9] DONG Xu-hua. Traffic forces and temperature effects on shear key connections for adjacent box girder bridge[D]. Ohio: University of Cincinnati, 2002. [10] GULYAS R J, WIRTHLIN G J, CHAMPA J T. Evaluation of keyway grout test methods for precast concrete bridges[J]. PCI Journal, 1995, 40(1): 44-57. doi: 10.15554/pcij.01011995.44.57 [11] YAMANE T, TADROS M K, ARUMUGASAAMY P. Short to medium span precast prestressed concrete bridge in Japan[J]. PCI Journal, 1994, 39(2): 74-100. doi: 10.15554/pcij.03011994.74.100 [12] 姜云霞, 柴金义, 伍必庆, 等. 不中断交通实施铰接板桥加固的研究[J]. 内蒙古公路与运输, 2002(2): 1-3. doi: 10.3969/j.issn.1005-0574.2002.02.002JIANG Yun-xia, CAI Jin-yi, WU Bi-qing, et al. Research on strengthening hinged slab bridge under uninterrupted traffic[J]. Highways and Transportation in Inner Mongolia, 2002(2): 1-3. (in Chinese) doi: 10.3969/j.issn.1005-0574.2002.02.002 [13] JT/GQB 002―93, 公路桥涵标准图: 装配式钢筋混凝土斜空心板桥上部构造[S].JT/GQB 002―93, standard drawings for highway bridges and culverts: superstructure of reinforced skew hinged voided slab bridges[S]. (in Chinese) [14] JT/GQB 001―93, 公路桥涵标准图: 装配式预应力混凝土斜空心板桥上部构造[S].JT/GQB 001―93, standard drawings for highway bridges and culverts: superstructure of prestressed skew hinged voided slab bridges[S]. (in Chinese) [15] 刘龄嘉, 贺拴海, 赵小星. 在役混凝土简支梁有效预应力计算[J]. 交通运输工程学报, 2005, 5(3): 47-51 doi: 10.3321/j.issn:1671-1637.2005.03.010LIU Ling-jia, HE Shuan-hai, ZHAO Xiao-xing. Effective prestress computation of existing PC simply-supported beam[J]. Journal of Traffic and Transportation Engineering, 2005, 5(3): 47-51. (in Chinese) doi: 10.3321/j.issn:1671-1637.2005.03.010 [16] 杨继新. 装配式空心板桥铰缝受力性能研究[D]. 内蒙古: 内蒙古工业大学, 2009.YANG Ji-xin. Study on mechanical properties of fabricated hollow slab bridge hinge joint under the load[D]. Inner Mongolia: Inner Mongolia University of Technology, 2009. (in Chinese) [17] 交通运输部. 公路桥涵通用图[M]. 北京: 人民交通出版社, 2006.Ministry of Transport. Standard Drawings of Highway Bridge and Culverts[M]. Beijing: China Communications Press, 2006. (in Chinese) [18] 叶见曙, 刘九生, 俞博, 等. 空心板混凝土铰缝抗剪性能试验研究[J]. 公路交通科技, 2013, 30(6): 33-39. doi: 10.3969/j.issn.1002-0268.2013.06.007YE Jian-shu, LIU Jiu-sheng, YU bo, et al. Experiment on shear property of hinge joints of concrete hollow slab[J]. Journal of Highway and Transportation Research and Development, 2013, 30(6): 33-39. (in Chinese) doi: 10.3969/j.issn.1002-0268.2013.06.007 [19] 种永峰. 空心板梁铰接缝模型试验研究[D]. 西安: 长安大学, 2008.ZHONG Yong-feng. Study on the hinge joint model experiment of hollow slab beam bridge[D]. Xi'an: Chang'an University, 2008. (in Chinese) [20] 刘沛林. 装配式钢筋混凝土简支板梁桥铰缝受力性能研究[D]. 北京: 清华大学, 2010.LIU Pei-lin. Study on behaviors of hinge joints for fabricated reinforced concrete simply-supported plate girder bridges[D]. Beijing: Tsinghua University, 2010. (in Chinese) [21] 刘健. 新老混凝土黏结的力学性能研究[D]. 大连: 大连理工大学, 2000.LIU Jian. Study on the mechanics performance of adherence of young on old concrete[D]. Dalian: Dalian University of Technology, 2000. (in Chinese)