Volume 8 Issue 1
. 
Turn off MathJax
Article Contents
Article Navigation >  Journal of Traffic and Transportation Engineering  > 2008  >  8(1): 1-4
WANG Yong, CENG Jing, WU Ping-bo. Dynamics simulation model of double united articulated container flat vehicle[J]. Journal of Traffic and Transportation Engineering, 2008, 8(1): 1-4.
Citation: WANG Yong, CENG Jing, WU Ping-bo. Dynamics simulation model of double united articulated container flat vehicle[J]. Journal of Traffic and Transportation Engineering, 2008, 8(1): 1-4.
shu

Dynamics simulation model of double united articulated container flat vehicle

  • Traction Power State Key Laboratory, Southwest Jiaotong University, Chengdu 610031, Sichuan, China

More Information
  • Author Bio:

    Wang Yong(1972-), male, PhD, lecturer, +86-28-86466424, wangyong_05@yahoo.com.cn

  • Received Date: 2007-06-14
  • Publish Date: 2008-02-25
    Abstract
  • Based on the characteristic that two carbodies of articulated container flat vehicle are connected with an articulated connector and a common articulated bogie is used at articulated position, a nonlinear mathematic model of the vehicle was established by using NUCARS dynamics simulation software, the nonlinearities were considered resulted from wheel/rail contact geometry, wheel/rail creep forces, nonlinear suspension characteristics and articulated connector, and its running stability, curve negotiating performance and riding comfortableness were studied by using numerical simulation method. Analysis result shows that the vehicle has enough high hunting critical speed, its curve negotiating performance indices are in the safe range required by GB/T 5599-1985, and the lateral and vertical indices of riding comfortableness are less than 3.5 at the running speed range of 120 km·h-1, so the vehicle has eximious dynamics performance, and meets the running requirement at 120 km·h-1.

     

    • FullText(HTML)
  • loading
    • References(10)
  • [1]
    宋国文. 2010年我国集装箱的发展模式[J]. 铁道车辆, 1996, 34(8): 6-8. https://www.cnki.com.cn/Article/CJFDTOTAL-TDCL608.001.htm

    Song Guo-wen. Model for development of container cars in our country in 2010[J]. Rolling Stock, 1996, 34(8): 6-8. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-TDCL608.001.htm
    [2]
    王起梁. 铰接式集装箱平车结构方案及动力学性能研究[D]. 成都: 西南交通大学, 2006.
    [3]
    吕倩. 出口澳大利亚5单元关节式集装箱平车[J]. 铁道车辆, 2005, 43(5): 13-16. doi: 10.3969/j.issn.1002-7602.2005.05.005

    Lu Qian. The 5-unit articulated container flat car exported to Australia[J]. Rolling Stock, 2005, 43(5): 13-16. (in Chinese) doi: 10.3969/j.issn.1002-7602.2005.05.005
    [4]
    周凌. 关节式集装箱平车发展方向探讨[J]. 铁道车辆, 2007, 45(7): 29-32. doi: 10.3969/j.issn.1002-7602.2007.07.010

    Zhou Ling. Discussion of the development orientation of articulated container flat cars[J]. Rolling Stock, 2007, 45(7): 29-32. (in Chinese) doi: 10.3969/j.issn.1002-7602.2007.07.010
    [5]
    王起梁, 曾京. 铰接式集装箱平车动力学建模与仿真[J]. 铁道车辆, 2006, 44(7): 3-8. https://www.cnki.com.cn/Article/CJFDTOTAL-TDCL200607001.htm

    Wang Qi-liang, Zeng Jing. The dynamics modeling and simulation of hinged type container flat cars[J]. Rolling Stock, 2006, 44(7): 3-8. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-TDCL200607001.htm
    [6]
    刘宏友, 杨爱国. 双层集装箱平车动力学性能仿真分析[J]. 交通运输工程学报, 2004, 4(3): 20-24. doi: 10.3321/j.issn:1671-1637.2004.03.006

    Liu Hong-you, Yang Ai-guo. Dynamics performance simulation of double-deckcontainer flat car[J]. Journal of Traffic and Transportation Engineering, 2004, 4(3): 20-24. (in Chinese) doi: 10.3321/j.issn:1671-1637.2004.03.006
    [7]
    王勇, 曾京, 张卫华. 铁道货车非线性稳定性研究[J]. 交通运输工程学报, 2002, 2(2): 36-40. http://transport.chd.edu.cn/article/id/200202009

    Wang Yong, Zeng Jing, Zhang Wei-hua. Nonlinear stability of rail way freight cars[J]. Journal of Traffic and Transportation Engineering, 2002, 2(2): 36-40. (in Chinese) http://transport.chd.edu.cn/article/id/200202009
    [8]
    Shen G, Pratt I. The development of a railway dynamics modeling and simulation package to cater for current indestrial trends[J]. Journal of Rapid Transit, 2001, 215(3): 167-178.
    [9]
    王勇. 两联关节式集装箱平车动力学性能计算[R]. 成都: 西南交通大学, 2005.
    [10]
    王勇, 曾京, 吕可维. 三大件转向架货车动力学建模和仿真[J]. 交通运输工程学报, 2003, 3(4): 30-34. http://transport.chd.edu.cn/article/id/200304018

    Wang Yong, Zeng Jing, Lu Ke-wei. Dynamics modeling and simulation of three-piece bogie freight car[J]. Journal of Traffic and Transportation Engineering, 2003, 3(4): 30-34. (in Chinese) http://transport.chd.edu.cn/article/id/200304018
    • Relative Articles
    • Supplements(0)
    • Cited By
  • 加载中

Catalog

    通讯作者: 陈斌, bchen63@163.com
    • 1. 

      沈阳化工大学材料科学与工程学院 沈阳 110142

    1. 本站搜索
    2. 百度学术搜索
    3. 万方数据库搜索
    4. CNKI搜索
    Get Citation
    PDF
    XML

    Article Metrics

    Article views (311) PDF downloads(219) Cited by()
    Proportional views
    Related

    Copyright《Journal of Traffic and Transportation Engineering》编辑部陕ICP备05001904号-1

    Address ：Editorial Department of Journal of Traffic and Transportation Engineering, Chang 'an University, Middle Section of South Second Ring Road, Xi 'an, Shaanxi（710064） Tel：029-82334388 Email：jygc@chd.edu.cn

    All visit:Today's visit:

    Supported by: Beijing Renhe Information Technology Co. Ltd    

    /

    DownLoad:  Full-Size Img  PowerPoint
    Return
    Return