Volume 17 Issue 2
. 
Turn off MathJax
Article Contents
Article Navigation >  Journal of Traffic and Transportation Engineering  > 2017  >  17(2): 83-89
LIU Zhi-jie, LIU Xiao-yu, XIONG Wei, LIN Cheng-xin. Optimization model of ballast water allocation for crane ship[J]. Journal of Traffic and Transportation Engineering, 2017, 17(2): 83-89.
Citation: LIU Zhi-jie, LIU Xiao-yu, XIONG Wei, LIN Cheng-xin. Optimization model of ballast water allocation for crane ship[J]. Journal of Traffic and Transportation Engineering, 2017, 17(2): 83-89.
shu

Optimization model of ballast water allocation for crane ship

  • Transportation Equipment and Ocean Engineering College, Dalian Maritime University, Dalian 116026, Liaoning, China

More Information
  • Author Bio:

    LIU Zhi-jie(1979-), male, associate professor, PhD, +86-411-84724292, liuzj2003@163.com

  • Received Date: 2016-11-15
  • Publish Date: 2017-04-25
    Abstract
  • Based on the hydrostatics and optimal theories of ship, the optimal model of ballast water allocation for crane ship was built.The optimal variables were the variations of water levels for all ballast tanks.The optimal objective was minimizing the ballast water's total allocation volume of ballast tanks.The constraint condition was hull balance in the lifting-allocating process.The ballast water allocation process of a crane ship with 8 ballast tanks was optimized by using MATLAB to reduce the energy consumption of crane ship.Calculation result shows that only 3 ballast tanks are used in the allocation process for the allocation scheme designed by engineering experience, and the requirement of hull balance is satisfied when the water in tank 1 is allocated into tanks 2, 8.When the proposed model is used, the water in tanks 1, 3, 4, 5, 6 is allocated into tanks 2, 8.Although 7 tanks are used in the allocation process, the total allocation volume reduces by 21% compared with the empirical scheme.For both the empirical scheme and optimal scheme, when the rotating angle of crane is 0, the ballast water allocation volumes are largest, and reach 487.5t and 256.0t, respectively.In order to avoid hull tilt caused by rapidly loading, the crane ship is loaded and allocated gradually at the moment.In the allocation process, when the water level of a ballast tank decreases to 0, the ballast water allocation volume will suddenly change at the next moment.At the moment, the crane should run slowly so that the ballast system can allocate enough ballast water to guarantee hull balance and avoid serious consequence.

     

    • FullText(HTML)
  • loading
    • References(23)
  • [1]
    张昊, 王辉, 何宁. 海洋工程大型起重设备及其关键技术研究[J]. 海洋工程, 2009, 27 (4): 130-139. https://www.cnki.com.cn/Article/CJFDTOTAL-HYGC200904022.htm

    ZHANG Hao, WANG Hui, HE Ning. Analysis of the key technology of the offshore engineering lift system and the crane[J]. The Ocean Engineering, 2009, 27 (4): 130-139. (in Chinese). https://www.cnki.com.cn/Article/CJFDTOTAL-HYGC200904022.htm
    [2]
    潘德位, 林成新, 孙德平, 等. 大倾角搁浅船舶扳正过程分析[J]. 交通运输工程学报, 2015, 15 (2): 50-58. doi: 10.3969/j.issn.1671-1637.2015.02.008

    PAN De-wei, LIN Cheng-xin, SUN De-ping, et al. Uprighting process analysis of big-angle tilted aground ship[J]. Journal of Traffic and Transportation Engineering, 2015, 15 (2): 50-58. (in Chinese). doi: 10.3969/j.issn.1671-1637.2015.02.008
    [3]
    WIECZOREK A J, NEGRO S O, HARMSEN R, et al. A review of the European offshore wind innovation system[J]. Renewable and Sustainable Energy Reviews, 2013, 26 (10): 294-306.
    [4]
    张志明, 徐丹铮, 张超, 等. 大型起重船船型开发的若干技术问题初探[J]. 船舶, 2005 (1): 10-15. https://www.cnki.com.cn/Article/CJFDTOTAL-CBZZ200501002.htm

    ZHANG Zhi-ming, XU Dan-zheng, ZHANG Chao, et al. Technical problems in ship type development of large crane ship[J]. Ship and Boat, 2005 (1): 10-15. (in Chinese). https://www.cnki.com.cn/Article/CJFDTOTAL-CBZZ200501002.htm
    [5]
    AHN D, SHIN S C, KIM S Y, et al. Comparative evaluation of different offshore wind turbine installation vessels for Korean west-south wind farm[J]. International Journal of Naval Architecture and Ocean Engineering, 2017, 9 (1): 45-54. doi: 10.1016/j.ijnaoe.2016.07.004
    [6]
    陈雷, 李含苹. 超大型起重船压载调载系统研究设计[J]. 船舶, 2010 (1): 34-38. https://www.cnki.com.cn/Article/CJFDTOTAL-CBZZ201001010.htm

    CHEN Lei, LI Han-ping. Research and design of ballast system for super large pontoon crane[J]. Ship and Boat, 2010 (1): 34-38. (in Chinese). https://www.cnki.com.cn/Article/CJFDTOTAL-CBZZ201001010.htm
    [7]
    黄超. 大型驳船型起重船的复合压载管路系统的优化研究[D]. 上海: 上海交通大学, 2012,

    HUANG Chao. Optimization study on ballast pipe system for large barge crane vessel[D]. Shanghai: Shanghai Jiaotong University. (in Chinese).
    [8]
    WRIGHT D A, DAWSON R, ORANO-DAWSON C E, et al. A test of the efficacy of a ballast water treatment system aboard the vessel Coral Princess[J]. Marine Technology, 2007, 44 (1): 57-67.
    [9]
    KLUG S. A control-system for an ultra-high-speed ballasting equipment[C]//Offshore Technology Conference. Proceedings of the Eleventh Annual OTC. Houston: Offshore Technology Conference, 1979: 307-314.
    [10]
    WOODS S A, BAUER R J, SETO M L. Automated ballast tank control system for autonomous underwater vehicles[J]. IEEE Journal of Oceanic Engineering, 2012, 37 (4): 727-739. doi: 10.1109/JOE.2012.2205313
    [11]
    张茴栋, 何炎平. 全回转起重船压载舱的优化探索[J]. 中国造船, 2010, 51 (2): 175-183. https://www.cnki.com.cn/Article/CJFDTOTAL-ZGZC201002024.htm

    ZHANG Hui-dong, HE Yan-ping. Study on optimizing ballast tanks for revolving derrick barge[J]. Shipbuilding of China, 2010, 51 (2): 175-183. (in Chinese). https://www.cnki.com.cn/Article/CJFDTOTAL-ZGZC201002024.htm
    [12]
    张茴栋, 何炎平, 李洪亮. 基于数值分析法的压载舱的优化设计[J]. 船舶工程, 2010, 32 (2): 60-63, 42. https://www.cnki.com.cn/Article/CJFDTOTAL-CANB201002017.htm

    ZHANG Hui-dong, HE Yan-ping, LI Hong-liang. Optimal design of ballast tanks based on numerical analysis method[J]. Ship Engineering, 2010, 32 (2): 60-63, 42. (in Chinese). https://www.cnki.com.cn/Article/CJFDTOTAL-CANB201002017.htm
    [13]
    李树敏. 大型海洋起重平台工作状态下压载水调配的实验研究[D]. 大连: 大连海事大学, 2013.

    LI Shu-min. Ballast experiment study of submersible crane vessel on working status[D]. Dalian: Dalian Maritime University, 2013. (in Chinese).
    [14]
    CHEN Jing, LIN Yan, HUO Jun-zhou, et al. Optimization of ship's subdivision arrangement for offshore sequential ballast water exchange using a non-dominated sorting genetic algorithm[J]. Ocean Engineering, 2010, 37 (11/12): 978-988.
    [15]
    雷坤, 林焰, 纪卓尚. 基于内点法的驳船接载配载方案优化模型[J]. 中国造船, 2010, 51 (2): 149-154. https://www.cnki.com.cn/Article/CJFDTOTAL-ZGZC201002020.htm

    LEI Kun, LIN Yan, JI Zhuo-shang. Optimization of ballast plan based on interior-point method in barge for load-out[J]. Shipbuilding of China, 2010, 51 (2): 149-154. (in Chinese). https://www.cnki.com.cn/Article/CJFDTOTAL-ZGZC201002020.htm
    [16]
    夏华波, 纪卓尚, 张明霞. 改进遗传算法在驳船配载中的应用[J]. 中国舰船研究, 2010, 5 (6): 51-55. https://www.cnki.com.cn/Article/CJFDTOTAL-JCZG201006011.htm

    XIA Hua-bo, JI Zhuo-shang, ZHANG Ming-xia. Application of Improved Genetic Algorithm in barge stowage planning analysis[J]. Chinese Journal of Ship Research, 2010, 5 (6): 51-55. (in Chinese). https://www.cnki.com.cn/Article/CJFDTOTAL-JCZG201006011.htm
    [17]
    SAMYN L M, PAULO J, CUNHA V S. Dynamic model of a semi-submersible platform for the development of ballast control systems[J]. IFAC Proceedings Volumes, 2009, 42 (18): 146-151.
    [18]
    MANZI M, SOLTANI B, GUERLAIN S, et al. Designing a ballast control system operator interface[C]//IEEE. 2005IEEE Design Symposium, Systems and Information Engineering. New York: IEEE, 2005: 242-248.
    [19]
    BARA C, CORNOIU M, POPESCU D. An optimal control strategy of ballast system used in ship stabilization[C]//IEEE. 20th Mediterranean Conference on Control and Automation. New York: IEEE, 2012: 878-883.
    [20]
    KURNIAWAN A, HARDIANTO, KOENHARDONO E S, et al. Modeling and control of ballast system to improve stability of catamaran boat[C]//IEEE. 2015International Conference on Advanced Mechatronics, Intelligent Manufacture, and Industrial Automation. New York: IEEE, 2015: 202-204.
    [21]
    LIU Yin-shui, ZHAO Xu-feng, WU De-fa, et al. Study on the control methods of a water hydraulic variable ballast system for submersible vehicles[J]. Ocean Engineering, 2015, 108: 648-661.
    [22]
    ZHAO Xu-feng, LIU Yin-shui, HAN Ming-xing, et al. Improving the performance of an AUV hovering system by introducing low-cost flow rate control into water hydraulic variable ballast system[J]. Ocean Engineering, 2016, 125: 155-169.
    [23]
    GOLZ M, BOECK F, RITZ S, et al. A ballast system for automated deep-sea ascents[C]//ASME. 35th International Conference on Ocean, Offshore and Article Engineering. New York: ASME, 2016: 1-5.
    • Relative Articles
    • Supplements(0)
    • Cited By
  • 加载中

Catalog

    通讯作者: 陈斌, bchen63@163.com
    • 1. 

      沈阳化工大学材料科学与工程学院 沈阳 110142

    1. 本站搜索
    2. 百度学术搜索
    3. 万方数据库搜索
    4. CNKI搜索
    Get Citation
    PDF
    XML

    Article Metrics

    Article views (822) PDF downloads(314) Cited by()
    Proportional views
    Related

    Copyright《Journal of Traffic and Transportation Engineering》编辑部陕ICP备05001904号-1

    Address ：Editorial Department of Journal of Traffic and Transportation Engineering, Chang 'an University, Middle Section of South Second Ring Road, Xi 'an, Shaanxi（710064） Tel：029-82334388 Email：jygc@chd.edu.cn

    All visit:Today's visit:

    Supported by: Beijing Renhe Information Technology Co. Ltd    

    /

    DownLoad:  Full-Size Img  PowerPoint
    Return
    Return