Performance comparison of asphalt macadam mixtures based on different molding methods
-
摘要: 为研究不同成型方法对沥青碎石混合料性能的影响及相关试验指标, 分别采用旋转压实法、振动压实法与大型马歇尔击实法成型沥青碎石混合料试件, 对试件各项马歇尔指标与采用不同振动时间成型的试件体积指标进行了对比分析, 并根据压实功相同原理, 提出了基于旋转压实成型法和振动压实成型法设计的4个指标范围。对比分析结果表明, 2种方法的指标范围基本相同, 仅沥青饱和度下限有5%差别; 同时强调, 在施工碾压时需保证足够的压实时间, 才能使沥青碎石混合料达到预期的设计效果。Abstract: In order to study the influences of different molding methods on the performances of asphalt macadam mixtures and the indices of mixture tests, three molding methods were utilized, including large scale Marshall molding method, rolling molding method and vibrating molding method, the Marshall indices of asphalt macadam mixtures compacted by the three methods were compared, and the volume indices of asphalt macadam mixtures with different vibration times were analyzed.Based on the principle of same compaction power, the ranges of four indices designed by using rolling molding method and vibrating molding method were put forward aimed at asphalt macadam mixtures.Test result shows that the ranges of different indices aimed at the two methods are nearly same, only with a difference of 5% in asphalt saturation degree, and enough compaction time is required for asphalt macadam mixtures in construction and compaction, so that they have good road performances.
-
Key words:
- pavement engineering /
- asphalt macadam mixtures /
- molding method /
- performance comparison
-
表 1 混合料级配
Table 1. Mixture gradations
筛孔尺寸/mm 不同级配各筛孔的通过率/% 2# 4# 6# 0.075 2.7 4.0 5.3 0.150 4.3 6.5 8.6 0.300 6.3 9.5 12.6 0.600 8.7 13.0 17.3 1.180 11.7 17.5 23.3 2.360 15.7 23.5 31.3 4.750 20.0 30.0 40.0 9.500 32.6 41.0 49.4 13.200 42.2 49.5 56.7 16.000 48.6 55.0 61.4 19.000 57.1 62.5 67.8 26.500 77.1 80.0 82.8 31.500 94.3 95.0 95.7 37.500 100.0 100.0 100.0 
下载: 导出CSV
表 2 马歇尔试验结果
Table 2. Result of Marshall test
级配类型 密度/(g·cm-3) 空隙率/% 矿料间隙率/% 沥青饱和度/% 稳定度/kN 流值/0.1mm 模数/(kN·mm-1) 2# 2.472 6.36 12.16 58.98 18.44 34.70 6.12 4# 2.484 5.54 12.05 63.51 26.64 32.90 8.51 6# 2.476 6.00 11.33 65.38 30.95 38.73 8.14
下载: 导出CSV
表 3 旋转压实试验结果
Table 3. Result of rolling compaction test
级配类型 密度/(g·cm-3) 空隙率/% 矿料间隙率/% 沥青饱和度/% 稳定度/kN 流值/0.1mm 模数/(kN·mm-1) 2# 2.473 6.31 11.06 63.69 18.50 41.80 4.42 4# 2.492 5.24 11.82 62.97 26.70 46.35 5.94 6# 2.476 5.98 12.06 60.48 31.03 45.95 6.91
下载: 导出CSV
表 4 振动成型试验结果
Table 4. Result of vibrating compaction test
级配类型 振动时间/s 密度/(g·cm-3) 空隙率/% 矿料间隙率/% 沥青饱和度/% 稳定度/kN 流值/0.1mm 模数/(kN·mm-1) 2# 80 2.477 6.17 12.18 58.91 19.67 55.90 3.56 4# 50 2.433 7.49 13.09 57.37 9.16 56.85 1.62 65 2.461 6.42 12.77 59.44 18.05 51.13 3.61 80 2.498 5.02 12.04 64.01 27.65 46.00 8.23 6# 80 2.480 5.85 11.23 66.12 31.61 44.15 7.16
下载: 导出CSV
表 5 旋转压实试验与马歇尔试验指标比值
Table 5. Index ratios between rolling compaction test and Marshall test
级配类型 成型方法 密度比值 空隙率比值 矿料间隙率比值 沥青饱和度比值 稳定度比值 流值比值 模数比值 2# 旋转压实100次, 马歇尔击实112次 1.001 0.992 0.910 1.101 1.003 1.205 0.723 4# 旋转压实100次, 马歇尔击实112次 1.003 0.945 0.980 0.998 1.002 1.409 0.698 6# 旋转压实100次, 马歇尔击实112次 1.000 0.996 1.064 0.940 1.002 1.186 0.880
下载: 导出CSV
表 6 旋转压实成型法控制指标
Table 6. Control indices of rolling compaction method
指标 设计空隙率/% 沥青饱和度/% 矿料间隙率/% 马歇尔稳定度/kN 建议标准 5.00~6.00 60.00~70.00 > 11.00 > 20.00
下载: 导出CSV
表 7 马歇尔指标比值
Table 7. Marshall index ratios
级配类型 成型方法 密度比值 空隙率比值 矿料间隙率比值 沥青饱和度比值 稳定度比值 流值比值 模数比值 2# 振动压实80 s, 马歇尔击实112次 1.002 0.970 1.001 0.999 1.067 1.611 0.582 4# 振动压实50 s, 马歇尔击实112次 0.979 1.350 1.086 0.902 0.344 1.728 0.191 振动压实65 s, 马歇尔击实112次 0.991 1.157 1.059 0.935 0.678 1.554 0.424 振动压实80 s, 马歇尔击实112次 1.006 0.906 0.998 1.007 1.038 1.398 0.967 6# 振动压实80 s, 马歇尔击实112次 1.002 0.975 0.991 1.011 1.021 1.140 0.824
下载: 导出CSV
表 8 振动压实成型法控制指标
Table 8. Control indices of vibrating compaction method
指标 设计空隙率/% 沥青饱和度/% 矿料间隙率/% 马歇尔稳定度/kN 建议标准 5.00~6.00 55.00~70.00 > 11.00 > 20.00
下载: 导出CSV
表 9 振动时间影响结果
Table 9. Influence result of vibrating time
级配类型 成型方法 密度比值 空隙率比值 矿料间隙率比值 沥青饱和度比值 稳定度比值 流值比值 模数比值 4# 振动压实65 s, 马歇尔击实112次 0.991 1.158 1.059 0.935 0.678 1.554 0.424 4# 振动压实50 s, 马歇尔击实112次 0.980 1.350 1.086 0.903 0.344 1.728 0.191
下载: 导出CSV
-
[1] Williams E G. Design and construction of large stone HMA bases in Kentucky[J]. Hot Mix Asphalt Technology, 1988, 31(1): 37-42. [2] Kandhal P S. Large stone asphalt mixes: design and construction[R]. Albuquerque: Annual Meeting of the Associa-tion of Asphalt Paving Technologists, 1990. [3] Anderson R M, Epley L E, Walker D. Kentucky's experience with large size aggregate in bituminous hot mix[J]. Journal of the Association of Asphalt Paving Technologists, 1991, 60(1): 1-18. [4] Donald K C. Designing asphalt concrete mixes which aremore readily compacted[J]. Journal of the Association of Asphalt Paving Technologists, 1998, 59(1): 341-359. [5] 黄晓明. 沥青稳定基层路面结构综述[J]. 河南交通科技, 1999, 19(3): 3-10. https://www.cnki.com.cn/Article/CJFDTOTAL-HNJK903.000.htmHuang Xiao-ming. Asummary of bituminous stabilized basepavement structure[J]. Science and Technology of Henan Communications, 1999, 19(3): 3-10. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-HNJK903.000.htm [6] 王富玉. 大粒径沥青混合料路用性能研究[D]. 西安: 长安大学, 2001. [7] 王旭东. 大型马歇尔击实试验研究[J]. 公路交通科技, 2002, 19(1): 16-19. doi: 10.3969/j.issn.1002-0268.2002.01.005Wang Xu-dong. Large scale Marshall compaction test study[J]. Journal of Highway and Transportation Research and Development, 2002, 19(1): 16-19. (in Chinese) doi: 10.3969/j.issn.1002-0268.2002.01.005 [8] 陆长兵, 黄晓明. 大型马歇尔试验击实次数[J]. 长安大学学报: 自然科学版, 2004, 24(1): 21-23. https://www.cnki.com.cn/Article/CJFDTOTAL-XAGL200401006.htmLu Chang-bing, Huang Xiao-ming. Striking times of largescale Marshall compactiontests[J]. Journal of Chang an University: Natural Science Edition, 2004, 24(1): 21-23. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-XAGL200401006.htm [9] 王富玉, 任立锋, 刘元烈. 大粒径沥青混合料的路用性能研究[J]. 公路交通科技, 2003, 20(5): 6-9. https://www.cnki.com.cn/Article/CJFDTOTAL-GLJK200305002.htmWang Fu-yu, Ren Li-feng, Liu Yuan-lie. Study on pavement performance of LSAM[J]. Journal of Highway and Transportation Research and Development, 2003, 20(5): 6-9. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-GLJK200305002.htm [10] 郭乃胜, 赵颖华, 孙略伦. 纤维掺量对聚醋纤维沥青混凝土韧性的影响[J]. 交通运输工程学报, 2006, 6(4): 32-35. doi: 10.3321/j.issn:1671-1637.2006.04.008Guo Nai-sheng, Zhao Ying-hua, Sun Lue-lun. Effect of fibercontents on toughness of polyester fiber asphalt concrete[J]. Journal of Traffic and Transportation Engineering, 2006, 6(4): 32-35. (in Chinese) doi: 10.3321/j.issn:1671-1637.2006.04.008 [11] 解晓光, 马松林, 王哲人. 沥青混合料马歇尔击实法与振动压实法成型工艺的比较研究[J]. 中国公路学报, 2001, 14(1): 9-12. https://www.cnki.com.cn/Article/CJFDTOTAL-ZGGL200101002.htmXie Xiao-guang, Ma Song-lin, Wang Zhe-ren. Study of compacting properties of asphalt mixture with Marshall and vibratory compaction method[J]. China Journal of Highway andTransport, 2001, 14(1): 9-12. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-ZGGL200101002.htm [12] JTG D50-2006, 公路沥青路面设计规范[S]. -
点击查看大图
计量
- 文章访问数: 253
- HTML全文浏览量: 86
- PDF下载量: 228
- 被引次数: 0
