Volume 22 Issue 1
Feb.  2022
Turn off MathJax
Article Contents
WEI Jian-gang, XIE Zhi-tao, YANG Yan, WU Qing-xiong, CHEN Bao-chun, PING Jian-chun. Experiment on out-of-plan mechanical behavior of CFST X-type arches[J]. Journal of Traffic and Transportation Engineering, 2022, 22(1): 58-69. doi: 10.19818/j.cnki.1671-1637.2022.01.004
Citation: WEI Jian-gang, XIE Zhi-tao, YANG Yan, WU Qing-xiong, CHEN Bao-chun, PING Jian-chun. Experiment on out-of-plan mechanical behavior of CFST X-type arches[J]. Journal of Traffic and Transportation Engineering, 2022, 22(1): 58-69. doi: 10.19818/j.cnki.1671-1637.2022.01.004

Experiment on out-of-plan mechanical behavior of CFST X-type arches

doi: 10.19818/j.cnki.1671-1637.2022.01.004
Funds:

National Natural Science Foundation of China 51878172

More Information
  • Author Bio:

    WEI Jian-gang(1971-), male, professor, PhD, weijg@fzu.edu.cn

    YANG Yan(1979-), female, associate professor, PhD, yangyan@fzu.edu.cn

  • Received Date: 2021-10-01
  • Publish Date: 2022-02-25
  • To investigate the effects of non-conservative forces on the out-of-plane stability of concrete filled steel tubular (CFST) X-type arches, the structural spatial mechanical behaviors of CFST X-type arches were analyzed via experiment and finite element analysis. Based on a prototype bridge, the structural spatial mechanical behaviors of a CFST X-type arch with hangers were tested to elucidate the failure mechanisms of the arch model. A finite element model of a standard CFST X-type arche was created based on the experimental data and the actual structural engineering parameters. The conservative and non-conservative forces from hangers were considered respectively in models with or without tie hangers. The effects of arch rib inclination, rise-span ratio, and width-span ratio on the out-of-plane ultimate bearing capacities of CFST X-type arches considering the non-conservative force from hangers or not were analyzed. Based on a finite element model for combined material and geometric nonlinearities and in terms of load and displacement ratios, the improvement in the spatial mechanical behaviors of arch rib due to the non-conservative force was quantitatively analyzed under different parameters. Research results indicate that during the spatial mechanical process, the displacement of the CFST X-type arch is symmetrically distributed about the crown section, and the strain distribution is also highly symmetric. Therefore, the arch model has good overall stability and low sensitivity to initial geometric defects during the spatial mechanical process. The arch model ultimately failed due to an out-of-plane extreme point instability. The arch rib mainly bears compression and out-of-plane bending moment, and the out-of-plane bending moment is the main controlling factor for the stability and ultimate bearing capacity of the arch model. The out-of-plane ultimate bearing capacity of CFST X-type arches initially increases and then decreases with the increasing arch rib inclination, rise-span ratio, and width-span ratio. The arch model reaches its maximum ultimate bearing capacity when the arch rib inclination is 9°, the rise-span ratio is 0.25, and the width-span ratio is 0.03. The non-conservative force should be considered when calculating the out-of-plane ultimate bearing capacity of CFST X-type arches, as the omission of the force will lead to a 22% underestimation of the out-of-plane ultimate bearing capacity. 1 tab, 21 figs, 32 refs.

     

  • loading
  • [1]
    LI Sheng-yong, CHEN Bao-chun. Stochastic static analysis on spatial stability of CFST tilt-basket arch bridge[J]. Journal of Changsha Communications University, 2008, 24(4): 1-5. (in Chinese) doi: 10.3969/j.issn.1674-599X.2008.04.001
    [2]
    CHEN Bao-chun, WEI Jian-gang, ZHOU Jun, et al. Application of concrete-filled steel tube arch bridges in China: current status and prospects[J]. China Civil Engineering Journal, 2017, 50(6): 50-61. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-TMGC201706006.htm
    [3]
    WEI Jian-gang, CHEN Jia-wei, XIE Zhi-tao, et al. Establishment and analysis of standard CFST X-type dumbbell-shaped cross-section arch bridge[J]. Journal of Fuzhou University (Natural Science Edition), 2019, 47(5): 663-668. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-FZDZ201905017.htm
    [4]
    DENG Ji-hua, ZHOU Fu-lin, TAN Ping. Study on method for calculating spatial ultimate load of circular CFST arch[J]. Journal of Building Structures, 2014, 35(11): 28-35. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-JZJB201411004.htm
    [5]
    GENG Yue, RANZI G, WANG Yu-tao, et al. Out-of-plane creep buckling analysis on slender concrete-filled steel tubular arches[J]. Journal of Constructional Steel Research, 2018, 140: 174-190. doi: 10.1016/j.jcsr.2017.10.010
    [6]
    CHEN Bao-chun, WEI Jian-gang, LIN Jia-yang. Experimental study on concrete filled steel tubular (single tube) arch with one rib under spatial loads[J]. Engineering Mechanics, 2006, 23(5): 99-106. (in Chinese) doi: 10.3969/j.issn.1000-4750.2006.05.018
    [7]
    SONG Fu-chun. Research on the out-of-plane stability of CFST truss ribs arches[D]. Fuzhou: Fuzhou University, 2009. (in Chinese)
    [8]
    GAO Jing, SU Jia-zhan, CHEN Bao-chun. Experiment on a concrete filled steel tubular arch with corrugated steel webs subjected to spatial loading[J]. Applied Mechanics and Materials, 2012, 166-169: 37-42. doi: 10.4028/www.scientific.net/AMM.166-169.37
    [9]
    WEI Jian-gang, LI Xiao-hui, CHEN Li-rong, et al. Experimental studies of out-of-plane mechanical behavior on CFST dumbbell section arch[J]. Engineering Mechanics, 2015, 32(11): 71-78. (in Chinese) doi: 10.6052/j.issn.1000-4750.2013.07.0602
    [10]
    SONG Fu-chun, CHEN Bao-chun. Analysis of out-of-plane elastic buckling of standard concrete filled steel tubular truss ribs arch[J]. Engineering Mechanics, 2012, 29(9): 125-132. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-GCLX201209021.htm
    [11]
    GENG Yue, ZHOU Chang-jie, WANG Yu-yin, et al. Out-of-plane buckling behavior of slender parabolic concrete-filled steel tubular arches with fixed ends[J]. Journal of Building Structures, 2015, 36(S1): 114-119. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-JZJB2015S1019.htm
    [12]
    HUANG Nai-qing, SHI Na. Influence of the stability of the transverse braces arrangement on basket-handle arch bridge[J]. Journal of Anhui Institute of Architecture and Industry (Natural Science), 2011, 19(5): 5-8. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-AHJG201105003.htm
    [13]
    SONG Fu-chun, WU Qian-na. Effects of crossbars on the lateral elastic stability of lift-basket CFST truss rib arch bridge[J]. Journal of Shenyang Jianzhu University (Natural Science), 2014, 30(5): 850-855. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-SYJZ201405012.htm
    [14]
    ZENG De-rong, ZHANG Qing-ming. Study on the stability influence of the angle of toe-in of the arch rib[J]. Journal of Chongqing Jiaotong University, 2006, 25(S1): 4-8. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-CQJT2006S1001.htm
    [15]
    ZHANG Qing-ming, ZHOU Gang. Study of effect of arch rib tilting angle on stability of long span basket handle arch[J]. Bridge Construction, 2007, 37(4): 32-34. (in Chinese) doi: 10.3969/j.issn.1003-4722.2007.04.009
    [16]
    YANG Yong-qing. Lateral stability of parabolic double-rib arch under directional loads[J]. Journal of Southwest Jiaotong University, 2003, 38(1): 43-48. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-XNJT200301010.htm
    [17]
    YANG Yong-qing, PU Qian-hui. Lateral stability of parabolic double-rib arch under non-directional loads[J]. Journal of Southwest Jiaotong University, 2003, 38(3): 309-313. (in Chinese) doi: 10.3969/j.issn.0258-2724.2003.03.016
    [18]
    GUO Yan-lin, ZHAO Si-yuan, PI Yong-lin, et al. An experimental study on out-of-plane inelastic buckling strength of fixed steel arches[J]. Engineering Structures, 2015, 98: 118-127. doi: 10.1016/j.engstruct.2015.04.029
    [19]
    LU Han-wen, LIU Ai-rong, PI Yong-lin, et al. Lateral-torsional buckling of arches under an arbitrary radial point load in a thermal environment incorporating shear deformations[J]. Engineering Structures, 2019, 179: 189-203. doi: 10.1016/j.engstruct.2018.10.071
    [20]
    GODDEN W G. The lateral buckling of tied arches[J]. Proceedings of the Institution of Civil Engineers, 1954, 3(4): 496-514.
    [21]
    ALMEIDA F N. Lateral buckling of twin arch ribs with transverse bars[D]. Columbus: The Ohio State University, 1970.
    [22]
    XIANG Hai-fan, QIAN Lian-ping. Practical calculation of lateral stability of single arch bridge[C]//China Civil Engineering Society. Proceedings of the First Urban Bridge Academic Conference of Municipal Engineering Professional Committee of China Civil Engineering Society. Beijing: China Civil Engineering Society, 1987: 693-699. (in Chinese)
    [23]
    JIN Cheng-di, ZHANG Jie, WANG Yi-hua. Analysis on the stability of a tied arch bridge[J]. Shanghai Highways, 2018(2): 1-6, 117. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-SHGL201802001.htm
    [24]
    WEI Jian-gang, PING Jian-chun, CHEN Li-rong, et al. Experimental study on spatial mechanical behavior of CFST arch under non-directional loads[J]. Journal of Building Structures, 2017, 38(S1): 451-456. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-JZJB2017S1065.htm
    [25]
    WANG Yu-tao. Out-of-plane buckling of CFST arches under non-directional loads[D]. Harbin: Harbin Institute of Technology, 2018. (in Chinese)
    [26]
    WU Qing-xiong, CHEN Bao-chun, WEI Jian-gang. A finite element method for analyzing material nonlinearity of concrete-filled steel tubular structures[J]. Engineering Mechanics, 2008, 25(6): 68-74. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-GCLX200806013.htm
    [27]
    WANG Yuan, YE Zhi-wei, WU Qing-xiong. Out-of-plane stability analysis for typical concrete-filled single steel circular tube arch bridge by finite element method[J]. World Bridges, 2015, 43(3): 38-43. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-GWQL201503011.htm
    [28]
    HU Jun-liang, YAN Quan-sheng, YU Xiao-lin, et al. Ultimate bearing capacity analysis of concrete filled steel tubular arch considering the initial defects' influence[J]. Advanced Materials Research, 2012, 1615(446/447/448/449): 1248-1251.
    [29]
    CHEN Bao-chun, LIU Fu-zhong, WEI Jian-gang. Statistical analysis of 327 concrete filled steel tubular arch bridges[J]. Journal of China and Foreign Highway, 2011, 31(3): 96-103. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-GWGL201103025.htm
    [30]
    CHEN Bao-chun, LIU Jun-ping. Review of construction and technology development of arch bridges in the world[J]. Journal of Traffic and Transportation Engineering, 2020, 20(1): 27-41. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-JYGC202001005.htm
    [31]
    RAJEEV S, PETER D J, VARKEY M V. Study of concrete filled steel tubular arch bridge: a review[J]. Applied Mechanics and Materials, 2016, 857: 261-266.
    [32]
    MOU Ting-min, FAN Bi-kun, ZHAO Yi-cheng, et al. Application and development of concrete-filled steel tubular bridges in China[J]. Highway, 2017, 62(12): 161-165. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-GLGL201712043.htm

Catalog

    Article Metrics

    Article views (1010) PDF downloads(116) Cited by()
    Related

    /

    DownLoad:  Full-Size Img  PowerPoint
    Return
    Return